- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 12:25 AM
i cant ping the host of location B (192.168.0.2) from location D(192.168.2.130) as it shows request timeout and packet is completely loss
Solved! Go to Solution.
- Labels:
-
LAN Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 01:53 AM
@bp01 check below guide for router ip configurations. also since you are trying to communicate between 2 networks, gateway is required to configure.
https://www.cisco.com/c/en/us/td/docs/routers/access/800M/software/800MSCG/routconf.html
Good luck
KB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 12:58 AM
Hi @bp01 share your pkt file here by zipping it.
Good luck
KB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 01:02 AM - edited 04-23-2023 02:50 AM
here you go
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 01:36 AM
@bp01 hi, i cant see any ip configured on your router in attached file. also gateway addresses are not configured in PCs.
Good luck
KB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 01:47 AM
@Kasun Bandara hi, im not sure how to configure ip on the router .Any example command where i can follow ?
And as for the gateway addresses, is it neccesary for basic ping connectivity only?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 01:53 AM
@bp01 check below guide for router ip configurations. also since you are trying to communicate between 2 networks, gateway is required to configure.
https://www.cisco.com/c/en/us/td/docs/routers/access/800M/software/800MSCG/routconf.html
Good luck
KB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 02:38 AM
heyy i think i got it ,for example Location A PCs will hav default gateway of Router FastEthernet 0/0 IP address, Location B PCs will hav default gateway of FastEthernet 1/0 IP address, my default gateway has been empty from the start
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2023 02:40 AM
ok. good luck with testings
Good luck
KB
