01-21-2010 05:27 PM - edited 03-06-2019 09:24 AM
Cat2950T-24 ___(link1)_____cat2950
<ios ver.>
cat2950T-24: 12.1(13)EA1
cat2950 : 12.1(22)EA8a
1) link1 down
2) I could find logs the following in the cat2950T-24
SPANTREE-7-RECV-1Q-NON-TRUNK:
SPANTREE-7-BLOCK-PORT-TYPE:
3) port, stp configurations are factory default
4) any change was none before then
5) That is repeated sometimes
What's the problem?, how can I fix it ?
Plz, help me
01-21-2010 05:37 PM
Can you post the configs for both switches?
Reza
01-21-2010 05:41 PM
Sorry, customer's policy don't allow it.
Almost configuration is factory default, and port/stp configuration is factory default.
01-21-2010 06:49 PM
Are both sides configured as an access ports or trunk port?
01-21-2010 08:00 PM
I didn't configure the ports "switch mode access" on both switches, so they operate in trunking (802.1q)
Cat2950 only support 802.1q
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: