Catalyst 1000 web GUI!

[Moudar]

Hi, 

I got a Catalyst 1000 switch (C1000-8FP-E-2G-L)

When i try to open the GUI i get this:

When i click on "Web Console - Manage the Switch through the web interface." i get 

404 Not Found

 Any ideas?!

[Mark Elsen]

 - You need to use software distribution  named 'with web based dev mgr' when downloading software from Cisco on it , 

 M.

[Moudar]

this is the installed image:

c1000-universalk9-tar.152-7.E4.tar

When i tried the other available image (c1000-universalk9-mz.152-7.E7.bin) on Cisco software download website, i got this error.

[Mark Elsen]

 - The ERROR for the bin file download means  that it is corrupt, anyway you don't need the single bin file ; check if there is an html directory in the C1000.... directory on the flash ; if not download and install the tar distribution again , 

 M.

[Moudar]

I am using this command to upload the image to the switch:

archive download-sw /image tftp://10.32.0.166/c1000-universalk9-tar.152-7.E4.tar

is it the right way to do it?

[Mark Elsen · Accepted solution]

  - You don't need /image flag ,  use /overwrite /reload    (the latter however will reboot the switch too) :
                archive download-sw /overwrite /reload  tftp://10.32.0.166/c1000-universalk9-tar.152-7.E4.tar

 M.

[Moudar]

Thank you, now it is working!

But what is this?

I tried Chrome and Firefox and got same result

[Mark Elsen]

                          - But what is this? : ...{{platform}} {{deviceDescription}}
  - That is a bug similar as in : https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvo35537

 M.

[Moudar]

the solution found in the CSCvo35337 does not work.

same problem continues to be there at the top of the page!!

[Mark Elsen]

       - It's a cosmetic issue , you may want to escalate to TAC , if desired , 

 M.

[Mark Elsen]

  (-Adding) : and  or use .tar extension  named file , 

 M.

[impulsion84]

And there i was thinking that i was the only one with this problem 🙂

[impulsion84]

This solved the issue for me: 

ip http authentication local

[sandeep_networkats]

Worked for me. Thanks for this quick tip.

[rptajpuriya]

config file is not found in C1000 Switch reset command output