Hi all!
I've gotten this out of our storage unit here at work:
This was not in use, I've restarted it, I can't get into the flash dir,I've tried to restart the switch via the documents I've gotten on the site.
I have the lastest iOS version .bin for this switch, but I can't get this to load: here below is what happens when I try.
START OF CISCO SWITCH LOG:
witch:
switch: memory
Text: 0x00700000 - 0x00721db8 (0x00021db8 bytes)
Rotext: 0x00721db8 - 0x00721db8 (0x00000000 bytes)
Data: 0x00721db8 - 0x0072a66c (0x000088b4 bytes)
Bss: 0x0072c57c - 0x0074e124 (0x00021ba8 bytes)
Stack: 0x0074e124 - 0x0075e124 (0x00010000 bytes)
Heap: 0x0075e128 - 0x00800000 (0x000a1ed8 bytes)
Bottom heap utilization is 2 percent.
Top heap utilization is 0 percent.
Total heap utilization is 2 percent.
Total bytes: 0xa1ed8 (663256)
Bytes used: 0x4710 (18192)
Bytes available: 0x9d7c8 (645064)
Alternate heap utilization is 0 percent.
Total alternate heap bytes: 0x6fd000 (7327744)
Alternate heap bytes used: 0x0 (0)
Alternate heap bytes available: 0x6fd000 (7327744)
switch: version
C3500XL Boot Loader (C3500-HBOOT-M) Version 12.0(5)WC2a, RELEASE SOFTWARE (fc1)
Compiled Tue 18-Dec-01 13:10 by devgoyal
switch: flash_init
Initializing Flash...
flashfs[0]: 0 files, 1 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 3612672
flashfs[0]: Bytes used: 1024
flashfs[0]: Bytes available: 3611648
flashfs[0]: flashfs fsck took 2 seconds.
...done Initializing Flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
Parameter Block Filesystem (pb:) installed, fsid: 4
switch: boot
Boot process failed...
switch: dir flash
unable to stat flash/: permission denied
switch: ?
? -- Present list of available commands
boot -- Load and boot an executable image
cat -- Concatenate (type) file(s)
copy -- Copy a file
delete -- Delete file(s)
dir -- List files in directories
flash_init -- Initialize flash filesystem(s)
format -- Format a filesystem
fsck -- Check filesystem consistency
help -- Present list of available commands
load_helper -- Load and initialize a helper image
memory -- Present memory heap utilization information
mkdir -- Create dir(s)
more -- Concatenate (display) file(s)
rename -- Rename a file
reset -- Reset the system
rmdir -- Delete empty dir(s)
set -- Set or display environment variables
set_param -- Set system parameters in flash
sleep -- Sleep a specified number of seconds
trap -- Cause a software breakpoint to occur
type -- Concatenate (type) file(s)
unset -- Unset one or more environment variables
version -- Display boot loader version
switch: dir
List of filesystems currently registered:
flash[0]: (read-write)
xmodem[1]: (read-only)
null[2]: (read-write)
bs[3]: (read-only)
switch:
Starting xmodem transfer. Press Ctrl+C to cancel.
How long should this take and I "chose" Transfer>Send Xmodem.. in SecureCRT
Will this work, any help would be great. Thanks!!
Kent C.
