04-27-2011 01:15 AM - edited 03-06-2019 04:48 PM
I am trying to configure 802.1x configuration on Catalyst 3750,
I am starting as a creating new aaa model, by using "aaa new-model" command.
But after I execute this command switch start to as for username and password on telnet session. How can I disable radius authentication on telnet and console session.
Thanks.
04-27-2011 01:27 AM
Hi,
try to config below.
line vty 0 4
no login local
password cisco
enable secret cisco
hth
Muammer
04-27-2011 02:42 AM
Hi,
You can disable the Radius authentication on telnet and console by applying the below commands in the config mode.
#set authentication login radius disable console
#set authentication login radius disable telnet
Please click on the correct answer if this answered your question.
Regards,
Naidu.
04-27-2011 03:05 AM
Switch does not recognize these command in privilege or config mode ?
In which mode should I enter them?
#set authentication login radius disable console
#set authentication login radius disable telnet
04-27-2011 03:15 AM
Hi,
Try below...
Console> (enable) set authentication login radius disable
radius login authentication set to disable for console and telnet session.
Console> (enable) set authentication enable radius disable
radius enable authentication set to disable for console and telnet session.
Console> (enable) show authentication
Please click on the correct answer if this answered your question.
Regards,
Naidu.
04-27-2011 03:26 AM
How can I enter console mode (console>) ?
I think it is different from privillege mode?
04-27-2011 03:52 AM
Hi,
Can you try below in global config mode.
no login authentication
Please click on the correct answer if this answered your question.
Regards,
Naidu.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: