11-15-2011 07:37 AM - edited 03-07-2019 03:24 AM
HI I am Dai from Japan.
I have question regarding convergence
time in case of stack master will be switched over to other switch.
In my understating, when the stack master will be switched over to other switch based on election algorithm, convergence
time will be less than 10 second.
I tried to calculate concersion time during fail over testing but convergence
time was 21 second. I think it is too long...
Please refer to the attached network diagram.
Expected reasons
・I configured Rapid Spanning tree protocol between L3 and L3.
(But RSTP's convergence time is 2~3 second..)
I want everyone's help...
Thanks and Best Regards, Dai
11-15-2011 07:05 PM
Hi,
Try this command and test the convergence time again:
stack-mac persistent
HTH
11-15-2011 09:13 PM
Thank you so much for your reply!
If you know exptected reason, please let me know..
First, I need to know expected reason..
Thank you!
07-10-2012 11:27 AM
Hi Mates,
I have the same sort of scenario
site A:3750 (stack)==>ASA5525 (ver8.6)---------IPSEC--------ASA5525 (ver8.6)===>site-B 3750(stack).....
Scenario of testing>>>
When I power off the stack Master of site B. My outage time is near about 51 sec.
Please help to reduce this stack convergence time.
Will appreciate anybody helping to reduce this outage time.
Thanks ....Sanjay
07-10-2012 10:23 PM
@ Sanjay
Can you post the configs and logs when you rebooted the stack master??
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide