Hello I have a 4510 Switch that is used as the Core Switch for the network, there are two 4516-10GE cards. As well as four 48 port blades, I would like all four of the gigabit uplinks on each of the 4516 cards to be active. The Ten Gigabit uplinks are not in use and will not be needed.
Currently since the Switch is set for redundancy in sso mode, only 2 of the uplinks are active on each card.
We do not need redundancy in the network as each uplink goes to a different Access Switch throughout the building.
If I issue the command " no redundancy " what affect can this have on the network ??
And will this make the 2 uplinks on each card show as " down" , instead of " inactive ".
The 4516 cards are in slots 5 and 6. Slot 5 is active and slot 6 is in standby.
Any input would be great.
Thanks
Nate.