Catalyst 9300 48 PoE+ (IOS-XE 16.8) - Modern equivalent of "radius-server host"?

[justanothersecuritydude]

On my 3850 I was able to configure radius using:

radius-server host 192.168.105.230 auth-port 1812 acct-port 1813 key 7 51304B00607FA327071223ABFB292022

The

radius-server host

command does not appear to exist anymore. What is the modern equivalent of the above line?

[Reza Sharifi · Accepted solution]

Try:

radius server <name>

and than 

address ipv4 ?

Link:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-8/configuration_guide/sec/b_168_sec_9300_cg/configuring_radius.html

HTH 

[marce1000 · Accepted solution]

 https://community.cisco.com/t5/switching/cisco-router-1900-ios-15-6-radius-server/td-p/2957934

M.

[justanothersecuritydude]

Thank you!

[Reza Sharifi]

Try this command:

hw-switch switch 1 logging onboard message level 3

link:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-6/configuration_guide/sys_mgmt/b_166_sys_mgmt_9300_cg/b_166_sys_mgmt_9300_cg_chapter_01100.html

HTH

[justanothersecuritydude]

That's the exact same command. See in the attached image in the original post? It tells me that it's not recommended, that it will soon be deprecated.