cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
201
Views
0
Helpful
2
Replies

Catalyst Switches GUI access with different privilege leves.

mishadib
Level 1
Level 1

Hi 
I hope somebody can help me with the problem I am facing. I am trying to setup on our switches (different models C9300, 3650 etc) access over GUI for our IT helpdesk to be able to do basic modification like interface description, shutdown and VLAN assignment to that interface. For that I enabled an account and I made priv level 5 with the following settings: 

#configure terminal
(config)#privilege exec level 5 configure terminal
(config)#privilege configure level 5 interface
(config)#privilege interface level 5 shutdown
(config)#privilege interface level 5 no shutdown

(config)#privilege interface level 5 description

In the CLI the priv level 5 works. I can go to conf t, change description shutdown.. all good. 

But in the GUI this user which is level 5 it is still assigned as read only and can't do any config modifications. 

Any ideas?

2 Replies 2

You need to config username privilege for GUI  

mishadib
Level 1
Level 1

How would I do that? 

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card