Change a stack member with a different model

[davidvidalp]

In a stack with 6 C9200L members, we have the need of replace one member for a issue with some ports.

The problem is that:

The actual model in the stack is C9200L-48P-4X and the temporary replacement switch is C9200L-48P-4G all with the same version of IOSXE (16.9.5)

It is possible to do this replacement (the switch to replace is a member, not the active nor Standby of stack) without problems with the config associated to replaced member?

The TenGigabitEthernet ports actually are unused, but many of the others 48 GigabitEthernet ports have a config.

There is a special procedure to do this replacement?

Thanks in advance.

[Reza Sharifi]

So, C9200L-48P-4X comes with 4 1/10Gig uplinks and C9200L-48T-4G comes with 4 1Gig uplinks. Other then the uplink speed, everything else is the same. So, you should be able to replace it with no issue. Just make sure you backup the config before adding the switch just in case.

HTH