Change management interface to access interface

[_Ratha_]

Dear all,

Currently, I am running Cisco ASA 5510. all interface are used and I need one more interface for additional requirement.

Can I use management interface to access interface?

How to do that?

[luckymike33]

Hi Ratha,

I am not sure I understand the issue here - normally you configure sub-interfaces to allow 'creation' of more interfaces. These are normally port-channeled back to your switch, then that interface is vlan tagged and that is a 'new' interface. I think you could also use the management interface in the data-plane but you need to remove the management-only command.

If that is not the information you are looking for - shout back.

Best wishes

Mike