Chej port and storm-control

[mehmetcc1989]

There are different devices attached to the switches, and these devices operate at different speeds.  I want to use storm control command if internet speed is 100mbit and above

can i do this with classmap or any other way?

[balaji.bandi]

we are not sure what is the use case  here - But technically possible depending on the model of the switch and the IOS code running.

[mehmetcc1989]

hello @balaji.bandi switch model WS-C3560CX-12PC-S , version 15.2(7)E5 and image C3560CX-UNIVERSALK9-M

thank you.

[balaji.bandi · Accepted solution]

we are not sure what is the use case here

[MHM Cisco World]

what is relate of storm control with internet speed ?
you need storm control in any internet speed.
or there is something else if you can share it with us.

[mehmetcc1989]

hello,

necessary to minimize the problems that may arise from the bandwidth in a restricted network infrastructure.

[MHM Cisco World]

I see one case that it fit to  your requirement 
the ISP router need SW with storm control. 

https://www.smitasin.com/docs/unknown-unicast-flooding.html

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/XE3-5-0E/15-21E/configuration/guide/config/bcastsup.pdf