Cisco 1805 VLAN problem

[jcclubb15]

Ok so I believe I have done everything right so any help would be greatly appreciated. Attached is my running config. I have the et0/0 set up for dhcp because it's connected to the outside network, the switch interface connected to vlan 2 which has a static ip, and i've also given my computer a static ip.                  

[milan_ver]

So What is the issue ???

[jcclubb15]

I'm getting no internet connection to my host computer

[Kyle McKay]

Hi Jeremiah,

There is not enough information here to be able to help you.

If you are using Fa0/0 as the uplink - where is NAT being performed? On the provider device?

If you need help I would need to see a diagram or a further explanation of the topology you are working in.

Thanks!