01-10-2020 07:45 AM
Hello my fiends,
I was wondering can someone point me in the right direction on this matter.
I have two Cisco 2960-X switches that needs power cords that are flat like 90 degrees angle cords. The network cabinet is just enough to fit the switches, but the switches cords are being smashed in the wall.
Can someone point me in the right direction so that I can buy this part to get this project completed and done for this new site.
Thanks
01-10-2020 07:51 AM
Hi there,
Just google: IEC C14 male right angle
cheers,
Seb.
01-10-2020 08:18 AM
01-10-2020 07:54 AM
Hi,
If there is no room in the back for the power cord, try adjusting the ear mounts so the switches sticks out a bit and leave some room for the power cord to bend..
HTH
01-10-2020 08:19 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide