06-10-2013 06:01 AM - edited 03-07-2019 01:48 PM
I have a Cisco 2800 router.
The Interface FA0/0 is connected to internet with a fix IP.
Interface FA0/1.1 isuse for the local data network.
Interface FA0/1.2 isuse for the local voice network.
Ports FA0/3/x are used to connected the IpPhone.
Router is connecting to internet and VPN is closing correctly.
FA0/1 is connected to a switch and computers connected to it can go on internet and reach the VPN.
The problem is with the Phone connected to FA0/3/x ports.
They are not getting IP in automatic so they are not registering.
If I connect a PC to one of this port, it get the IP but I'm not able to access any network (local, internet or VPN).
I tried to configure port in trunk or access mode without success.
In attachment running config.
Do you have any suggestions?
Thanks,
Matteo
06-10-2013 09:21 AM
Matteo
In looking at the config that you have posted I notice that on the interfaces of FastEth0/3/x all but two are configured with switchport mode trunk and then a voice vlan statement. I would suggest that you configure all these interfaces as access ports in vlan 1 with a voice vlan of vlan 2.
HTH
Rick
06-10-2013 10:01 AM
Hi Rick,
thank you for the replay.
At the beginning I had all the ports set in trunk.
I now set all the ports like following
interface FastEthernet0/3/0
switchport voice vlan 2
auto qos voip
But I still have the same problem.
If I connect a computer to one of the the FA0/3, it will not find DHCP too.
Thanks
Matteo
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide