cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
823
Views
0
Helpful
1
Replies

CISCO 2811 Boot Problem

raschlosser
Level 1
Level 1

Hi All,

i have an Cisco 2811.

Now the System hangs up in rommon (it works before).

I performed the boot flash: command and the system extract the IOS. But then the foolowing messages came up:

Queued messages:

*Aug 24 14:12:18.607: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.

*Aug 24 14:12:18.551: %SMC-2-FAILED_ID_HW: Failed Identification Test in 0/-1/-1 [4/0]

c2811 platform with 524288 Kbytes of main memory

Main memory is configured to 64 bit mode with ECC enabled

Readonly ROMMON initialized

rommon 1 >

As you see again in the rommon.

I removed all modules but it is still the same.

Did someone faced the same problen and saved it?

Thanks and Regards

Regards Ralf

1 Reply 1

Peter Paluch
Cisco Employee
Cisco Employee

Ralf,

It seems that your issue is similar to this one:

https://supportforums.cisco.com/message/3318783#3318783

Unfortunately, this seems to require a TAC assistance.

Best regards,

Peter