05-06-2019 08:07 AM
Hi,
We have recently installed a Cisco WS-C2960L-SM-24TS 15.2(6)E2b.
For reminder, the switch is configured on Web interface and cli on read only.
I have configured a port in access mode vlan 7 and then moved it to trunk.
The issue is that on cli, i can see both configuration on the interface and no way to clear it:
interface GigabitEthernet0/22
switchport access vlan 7
switchport mode trunk
!
On the web interface: it is trunk.
Solved! Go to Solution.
05-07-2019 12:09 AM
Hi Reza,
Thanks for your reply. The solution makes sense except the catalyst 2960 is a smart switch. The CLI is in read only and the configuration is done on web.
Since the switchport access vlan 7 does not impact the trunk operation, then there is no issue.
Thanks
05-06-2019 08:08 AM
05-06-2019 11:55 AM
Hi,
The additional command does not harm anything. Not familiar with the Web interface but on the cli, you can negate vlan 7 (no switchport access vlan 7).
HTH
05-07-2019 12:09 AM
Hi Reza,
Thanks for your reply. The solution makes sense except the catalyst 2960 is a smart switch. The CLI is in read only and the configuration is done on web.
Since the switchport access vlan 7 does not impact the trunk operation, then there is no issue.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide