06-20-2016 03:14 AM - edited 03-08-2019 06:16 AM
hi ,
i was trying to enable switch port port-security on cisco 2960 switch.
it was saying as "command rejected: switch port f0/2 is dynamic port "
any one provide the solution for this problem
Thanking you,
06-20-2016 03:37 AM
Yes 1st put it in access mode
switchport mode access
then try the port-security command
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community