11-12-2014 07:23 PM - edited 03-07-2019 09:29 PM
Hi all,
We're planning buy 6 set of Cisco 2960-X with stacking with existing two firewall with HA function (please see attached diagram), if firewall 01 down will auto failover to firewall 02, is this network design good ?
Please some expert give us suggestion.
Thanks
11-15-2014 08:54 AM
Hi Leo,
Can FlexStack with two WS-C2960X-48LPD-L and one WS-C2960X-24PS-L ?
Thanks
11-15-2014 03:12 PM
Can FlexStack with two WS-C2960X-48LPD-L and one WS-C2960X-24PS-L ?
As long as you FlexStack modules and cables to go with them, yes.
Make sure all the switch stack members are running the same IOS.
04-15-2015 08:34 AM
Hello Leo,
Can Cisco FlexStack 3m stacking cable install to 2960-X FlexStack Plus Stacking Module?
It is showing Plus on module, is this FlexStack (no plus) support ?
Thanks
04-15-2015 03:17 PM
Can Cisco FlexStack 3m stacking cable install to 2960-X FlexStack Plus Stacking Module? It is showing Plus on module, is this FlexStack (no plus) support ?
Hi Wilson,
The FlexStack module for the 2960S and 2960X/XR are totally different but the cables are the same.
01-07-2018 06:13 PM
Hi everyone!
I have a very close problem about this topic. I nedd to stack 8 2960X with 1RU space between each other. Wich is the best flexcable type (length)?
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: