After configuring "auto qos voip cisco-phone" on a stack of 2960x switches, we later noticed that after a power cycle (config was saved first) it went missing when doing a "show run" from the interface configs, on one of the switches (g1/0/1-48 had it applied, then after power cycle it didn't show). However, doing a "show auto qos interface" shows it is still applied to all interfaces g10/1-48.
I try to do "auto qos voip cisco-phone" again on g1/0/1-48, and it shows this:
SwitchStack01(config-if-range)#auto qos voip cisco-phone
AutoQoS Error: AutoQoS already configured
% Range command terminated because it failed on GigabitEthernet1/0/1
If I attempt to remove "auto qos voip cisco-phone", it shows this:
SwitchStack01(config-if-range)#no auto qos voip cisco-phone
AutoQoS Error: AutoQoS not configured
% Range command terminated because it failed on GigabitEthernet1/0/1
When I do a "show run", it is no longer displayed for the first switch of the stack.So is it still applied to the interfaces or not? Is this a bug? Has anyone else experienced this? This has happened to at least a couple stacks of 2960x's we have.
Thanks!