Dear Forums,
I'm currently configuring a bunch of Cisco 2960X switches and would like to secure access to SNMP for IPv6 and IPv4 with the following commands:
#snmp-server community public ro ipv6 ipv6-acl
#snmp-server community public ro ipv4-acl
However, only the last command I entered is added to the configuration so I've the choice between securing the community with an IPv4 or IPv6 ACL. Is this by design or is there another way to apply both IPv4 and IPv6 ACLs at the same time to the SNMP community?
Thanks,
Michael