02-26-2013 01:46 AM - edited 03-07-2019 11:56 AM
Dear everyone
I have a Cisco switch 3400-ME, it's running IOS1.bin file. Now i want to change the running IOS to IOS0.bin
I entered 2 commands:
boot system flash:dir1/IOS0.bin
boot system flash:dir1/IOS1.bin
But when i show running config, it has no any boot system commands.
I'm confuse that what happen when i relboot that switch ??
Rgds
02-26-2013 01:48 AM
But when i show running config, it has no any boot system commands.
The correct command to show the boot variable is "sh bootvar".
02-26-2013 05:43 PM
Tks but that command seems to be not working for me. I only can take the "sh boot" command
Sw-cus2-3400#show bootvar
^
% Invalid input detected at '^' marker.
Sw-cus2-3400#show boot
BOOT path-list : flash:me340x-metrobase-mz.122-37.SE1/me340x-metrobase-mz.122-37.SE1.bin
Config file : flash:/config.text
Private Config file : flash:/private-config.text
Enable Break : no
Manual Boot : no
HELPER path-list :
Auto upgrade : yes
Auto upgrade path :
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide