cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

2726
Views
20
Helpful
20
Replies
Beginner

Re: Cisco 3560 connected to Linksys WRT54G

Thanks for your help.  I will give it a try tonight and see.

Beginner

Re: Cisco 3560 connected to Linksys WRT54G

It worked out like you suggested.  Thanks for your help, I really appreciate it.

Beginner

Re: Cisco 3560 connected to Linksys WRT54G

If you ping from Vlan 2 to th ip address for linksys ? is it replay ?

,,,,,,,,,,

Did you configure DNS in hosts in Vlan 2 ? will be the linksys IP

Beginner

Re: Cisco 3560 connected to Linksys WRT54G

Yes, if I ping the IP address of the Linksys from vlan 2 it does reply.  DNS is set as the IP of the Linksys too.  Thanks.

Beginner

Re: Cisco 3560 connected to Linksys WRT54G

yes , you must add default route

Highlighted
Beginner

Re: Cisco 3560 connected to Linksys WRT54G

I had similar problem, and I found a better solution, wrt routers has got a static route function where you can give the static routes.
for example if your wrt is 192.168.1.1 and your 3560 is 192.168.1.2 and you have got 192.168.2.0 and 192.168.3.0 (vlan inter routing) then you have to set up a static route on your wrt like this:
destination: 192.168.2.0
mask: 255.255.255.0
gateway interface (where's your cisco connected)
gatway address 192.168.1.2
and
destination: 192.168.3.0
mask: 255.255.255.0
gateway interface (where's your cisco connected)
gatway address 192.168.1.2

 

set your 3560 like this
int vlan 1
ip address 192.168.1.2 255.255.255.0
!
int vlan 2
ip address 192.168.2.1 255.255.255.0

!

int vlan 3
ip address 192.168.2.1 255.255.255.0
!
ip route 0.0.0.0 0.0.0.0 192.168.1.1


I hope this will helps somebody in the future, because this question is quiet old.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards