cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1563
Views
0
Helpful
2
Replies

Cisco 3560 POE issue

nawas
Level 4
Level 4

I keep getting the following error when I connect a pc to some of the  ports in

Cisco 3560 (WS-C3560-48PS)

Aug 11 10:25:41.593: %ILPOWER-5-ILPOWER_POWER_DENY: Interface Fa0/30: inline power denied

Aug 11 08:17:08.293: %ILPOWER-7-DETECT: Interface Fa0/21: Power Device detected: IEEE PD
Aug 11 08:17:08.293: %ILPOWER-5-ILPOWER_POWER_DENY: Interface Fa0/21: inline power denied

Device I'm connecting are non POE, I went into the configuration mode and set "power

inline never" but still everytime I connect a device it throw this error and port shows

not connected. Please advise

2 Replies 2

dirao
Cisco Employee
Cisco Employee

Hi Nawas,

A faulty ethernet port on the end device (PC) could sometimes cause this issue, and have it detected as an IEEE PD. Is this the same device you are testing with on different ports of the 3560? If so could you test with a different PC and cable and check if you are still seeing the problem?

Thanks,

Divya

Leo Laohoo
Hall of Fame
Hall of Fame

Use the interface command "power inline never" and the repetitive logs will go away.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card