hi all,
i've got an issue with a new cisco 3650 48 port wherein older AP 1231 keeps on disconnecting.
the connection is just a simple trunk.
#sh run int g1/0/47
Building configuration...
Current configuration : 62 bytes
!
interface GigabitEthernet1/0/47
switchport mode trunk
end
1231 is working fine on a 3560.
could someone advice if anything else need to do on 3650?
*Apr 21 09:32:33.243: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/47, changed state to down
*Apr 21 09:32:34.255: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/47, changed state to down
*Apr 21 09:32:37.369: %ILPOWER-7-DETECT: Interface Gi1/0/47: Power Device detected: IEEE PD
*Apr 21 09:32:40.406: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/47: PD removed
*Apr 21 09:32:40.407: %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/47: Power given, but Power Controller does not report Power Good
*Apr 21 09:32:48.994: %ILPOWER-7-DETECT: Interface Gi1/0/47: Power Device detected: Cisco PD
*Apr 21 09:32:49.473: %ILPOWER-5-POWER_GRANTED: Interface Gi1/0/47: Power granted
*Apr 21 09:32:53.355: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/47, changed state to up
*Apr 21 09:32:55.356: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/47, changed state to up
*Apr 21 09:34:27.142: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/47: PD removed
*Apr 21 09:34:27.142: %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/47: Power Controller reports power Imax error detected
*Apr 21 09:34:27.847: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/47, changed state to down
*Apr 21 09:34:28.855: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/47, changed state to down
*Apr 21 09:34:39.384: %ILPOWER-7-DETECT: Interface Gi1/0/47: Power Device detected: Cisco PD
*Apr 21 09:34:40.235: %ILPOWER-5-POWER_GRANTED: Interface Gi1/0/47: Power granted
*Apr 21 09:34:43.875: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/47, changed state to up
*Apr 21 09:34:45.874: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/47, changed state to up
