Cisco 3650 Switch (Install Mode) - boot variable??

[handsy]

Hi,

I used the 'software install file tftp' command to upgrade software on my stacked pair of new 3650 switches. 

Do I now need to run the old 'boot system' command to tell the stack what to boot to on next reload?

Any help appreciated :)

Mark

[Madhukrishnan Gopinathan Nair · Accepted solution]

Hi,

What is your boot command now ? Is it pointing to packages.conf ? If so i you don't need to.

Thanks,

Madhu.

[handsy]

Yes it is, I see that now. Many thanks :)