Cisco 3650 upgrade usb

[Carl Steben]

Hi .. i'm trying to upgrade a stand alone 3650 to version cat3k_caa-universalk9.16.01.02.SPA.bin

Switch Ports Model              SW Version        SW Image              Mode
------ ----- -----              ----------        ----------            ----
*    1 52    WS-C3650-48PS      Denali 16.1.1     CAT3K_CAA-UNIVERSALK9 INSTALL

I'm in enable  and doing this command

software install file usbflash0:cat3k_caa-universalk9.16.01.02.SPA.bin

And i'm getting this..   can't figure it out.

SWITCH1#$stall file usbflash0:cat3k_caa-universalk9.16.01.02.SPA.bin
         ^
% Invalid input detected at '^' marker.

SWITCH1#sh usbflash0:
-#- --length-- ---------date/time--------- path
  2       4096 Dec 02 2015 16:31:32.0000000000 +00:00 System Volume Information
  3         76 Dec 02 2015 16:31:32.0000000000 +00:00 System Volume Information/
IndexerVolumeGuid
  4  471152396 Mar 01 2016 18:36:14.0000000000 +00:00 cat3k_caa-universalk9.16.0
1.02.SPA.bin
1528205312 bytes available (471166976 bytes used)

Anyone can guide me..  i'm clueless

[Leo Laohoo]

I think it should be "software install file usbflash0-1:cat3k_caa-universalk9.16.01.02.SPA.bin".

[Carl Steben]

SWITCH1#$stall file usbflash0-1:cat3k_caa-universalk9.16.01.02.SPA.bin
software install file usbflash0-1:cat3k_caa-universalk9.16.01.02.SPA.bin
 ^
% Invalid input detected at '^' marker.

SWITCH1#

Same thing.

[johnlloyd_13 · Accepted solution]

hi,

can you try below and do a reload on the switch?

3650#copy usbflash0:cat3k_caa-universalk9.16.01.02.SPA.bin flash

3650#boot system switch all flash:cat3k_caa-universalk9.16.01.02.SPA.bin flash

[Carl Steben]

i'm not able to copy it to flash  not enought space

[Carl Steben]

I have cleaned up some files and it worked your way

What is the best way to save the config, vlan.dat then format the flash:

I would like to get that switch clean

[Leo Laohoo]

Carl, 

Can you post an image as to where the "^" is located?  

[Carl Steben]

anyone ??