12-23-2013 11:05 AM - edited 03-07-2019 05:13 PM
I have a Cisco 4506 switch and its 10 gig interface is in error disable mode.I tried Shut and no shut the port couple of times but it transits from up to down number of times and then to error-disable. Did anyone else encountered this issue before. kindly advise the solution for the same. thanks
12-23-2013 11:24 AM
Hi Shariq,
Can you post the output of the show interface status err-disable ? That output contains the reason for putting your port into err-disabled state.
Best regards,
Peter
05-15-2015 07:48 AM
Dear All,
Do we have a solution for the same as we are having the same problem.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide