Cisco 5548UP initial configuration

[Frank27]

Hi,

I have a 5548UP , but looks like very different from the old Cisco Switches I used before.

I cannot find any initial configuration guide and I would like to use it as a basic layer 2 switch plus configuring an IP to be able to be reachable from the outside.

Any suggestion available?

Thank You.

[balaji.bandi · Accepted solution]

is this single switch (then ignore vpc part, just configure as normal config)

https://networkphil.com/2015/12/07/cisco-nexus-switches-part-2-basic-configuration/

[Frank27]

thanks a lot! i will give a try and report back here if i encounter problems. 

For the moment, again, thank you.

[balaji.bandi]

when you see issue post show run of nexus device so we can guide you what we can.

[Frank27]

that guide was very useful.

As a kick-off start is important to enable inter-vlan interfaces and remember to set the exact speed for each SFP and activate first the Rapid Spanning tree for each vlan