Hi,
I am trying to upgrade 6880-X using ISSU and it just goes back to old IOS.
Currently running 15.2(1)SY4 and upgrading to 15.2(1)SY7
I tried to issue this command and it upgraded the secondary chassis.
issu loadversion 1/5 bootdisk:c6880x-adventerprisek9-mz.SPA.152-1.SY7.bin 2/5 slavebootdisk:c6880x-adventerprisek9-mz.SPA.152-1.SY7.bin
I can see that the secondary chassis upgraded to SY7 then after a FPGA upgrade, it boots the chassis back to SY4. I get this message every time.
*Feb 14 22:03:59.355: %ISSU_PROCESS-SW2-3-IMAGE: Active is loading the wrong image [ bootdisk:c6880x-adventerprisek9-mz.SPA.152-1.SY7.bin ], expected image [ bootdisk:/c6880x-adventerprisek9-mz.SPA.152-1.SY4.bin ]
*Feb 14 22:03:59.359: %RF-SW2-5-RF_RELOAD: Shelf reload. Reason: Active is loading the wrong image
!
*Feb 14 22:04:00.891: %LINEPROTO-SW2-5-UPDOWN: Line protocol on Interface Loopback0, changed state to up
*Feb 14 22:04:01.391: %SYS-SW2-5-RELOAD: Reload requested by Delayed Reload. Reload Reason: Active is loading the wrong image.
Cisco Governator Rommon version 1.1
It will then go to recovery-mode then it will then reboot again after 10-15 minutes then boot back to SY4.
The VSS chassis are back to operational state without getting upgraded.
Any idea guys?
Thanks!
