03-29-2012 11:34 PM - edited 03-07-2019 05:52 AM
I try to upgrade Cisco 7606-s according to this instruction:
http://www.cisco.com/en/US/docs/routers/7600/ios/12.2SR/configuration/guide/redund.html#wp1089399
After uploading new IOS and reload, second RSP720-3CXL-GE in 6 slot doesn't work. All LEDs are orange.
When I exec sh file system, I don't see slavesup-bootdisk:
Could you some advices to me about this problems?
[1] sh ver
Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 15.2(1)S1, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Thu 16-Feb-12 01:34 by prod_rel_team
ROM: System Bootstrap, Version 12.2(33r)SRE, RELEASE SOFTWARE (fc1)
BOOTLDR: Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 15.2(1)S1, RELEASE SOFTWARE (fc2)
7606_5 uptime is 6 hours, 7 minutes
Uptime for this control processor is 6 hours, 7 minutes
System returned to ROM by reload (SP by reload)
System image file is "sup-bootdisk:/c7600rsp72043-advipservicesk9-mz.152-1.S1.bin"
Last reload type: Normal Reload
Last reload reason: power-on
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
Cisco CISCO7606-S (M8500) processor (revision 1.1) with 1900544K/131072K bytes of memory.
Processor board ID FOX1547G7YQ
BASEBOARD: RSP720
CPU: MPC8548_E, Version: 2.1, (0x80390021)
CORE: E500, Version: 2.2, (0x80210022)
CPU:1200MHz, CCB:400MHz, DDR:200MHz,
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Last reset from power-on
1 Virtual Ethernet interface
28 Gigabit Ethernet interfaces
3964K bytes of non-volatile configuration memory.
500472K bytes of Internal ATA PCMCIA card (Sector size 512 bytes).
Configuration register is 0x2102
[2] sh platform hardware capacity
System Resources
PFC operating mode: PFC3CXL
Supervisor redundancy mode: administratively sso, operationally sso
Switching resources: Module Part number Series CEF mode
4 WS-X6724-SFP CEF720 CEF
5 RSP720-3CXL-GE supervisor CEF
6 RSP720-3CXL-GE supervisor CEF
Power Resources
Power supply redundancy mode: administratively redundant
operationally redundant
System power: 2669W, 0W (0%) inline, 986W (37%) total allocated
Powered devices: 0 total, 0 Class3, 0 Class2, 0 Class1, 0 Class0, 0 Cisco
Flash/NVRAM Resources
Usage: Module Device Bytes: Total Used %Used
4 dfc#4-bootflash: 15990784 0 0%
5 SP sup-bootdisk: 512081920 354312192 69%
5 SP const_nvram: 127212 556 1%
5 SP hidden-nvram: 4059328 14008 1%
5 RP nvram: 4059328 14008 1%
5 RP bootdisk: 512081920 0 0%
CPU Resources
CPU utilization: Module 5 seconds 1 minute 5 minutes
4 11% / 0% 11% 11%
5 RP 2% / 1% 3% 3%
5 SP 3% / 0% 6% 5%
Processor memory: Module Bytes: Total Used %Used
4 182995472 61962888 34%
5 RP 1682043956 188292640 11%
5 SP 629718928 232663176 37%
I/O memory: Module Bytes: Total Used %Used
5 RP 134217728 51101520 38%
5 SP 67108864 43819664 65%
EOBC Resources
Module Packets/sec Total packets Dropped packets
4 Rx: 11 432416 0
Tx: 7 144711 0
5 RP Rx: 14 316873 0
Tx: 14 306688 0
5 SP Rx: 10 279653 0
Tx: 16 423051 0
VLAN Resources
VLANs: 4094 total, 5 VTP, 0 extended, 26 internal, 4063 free
L2 Forwarding Resources
MAC Table usage: Module Collisions Total Used %Used
5 0 98304 17 1%
VPN CAM usage: Total Used %Used
512 0 0%
L3 Forwarding Resources
Module FIB TCAM usage: Total Used %Used
5 72 bits (IPv4, MPLS, EoM) 524288 2364 1%
144 bits (IP mcast, IPv6) 262144 9 1%
detail: Protocol Used %Used
IPv4 316 1%
MPLS 2048 1%
EoM 0 0%
IPv6 2 1%
IPv4 mcast 4 1%
IPv6 mcast 3 1%
Adjacency usage: Total Used %Used
1048576 12712 1%
Forwarding engine load:
Module pps peak-pps peak-time
5 1491 13724 05:52:10 UTC Fri Mar 30 2012
Netflow Resources
TCAM utilization: Module Created Failed %Used
5 15490 0 5%
ICAM utilization: Module Created Failed %Used
5 0 0 0%
Flowmasks: Mask# Type Features
IPv4: 0 reserved none
IPv4: 1 Intf FulNAT_INGRESS NAT_EGRESS FM_GUARDIAN
IPv4: 2 unused none
IPv4: 3 reserved none
IPv6: 0 reserved none
IPv6: 1 unused none
IPv6: 2 unused none
IPv6: 3 reserved none
CPU Rate Limiters Resources
Rate limiters: Total Used Reserved %Used
Layer 3 9 6 1 67%
Layer 2 4 2 2 50%
ACL/QoS TCAM Resources
Key: ACLent - ACL TCAM entries, ACLmsk - ACL TCAM masks, AND - ANDOR,
QoSent - QoS TCAM entries, QOSmsk - QoS TCAM masks, OR - ORAND,
Lbl-in - ingress label, Lbl-eg - egress label, LOUsrc - LOU source,
LOUdst - LOU destination, ADJ - ACL adjacency
Module ACLent ACLmsk QoSent QoSmsk Lbl-in Lbl-eg LOUsrc LOUdst AND OR ADJ
5 1% 2% 1% 1% 1% 1% 0% 0% 0% 0% 1%
L3 Multicast Resources
Replication mode: Egress
Replication capability: Module Mode
4 Egress
5 Egress
MET table Entries: Module Total Used %Used
5 32744 2 1%
QoS Policer Resources
Aggregate policers: Module Total Used %Used
5 1024 1 1%
Microflow policer configurations: Module Total Used %Used
5 64 1 1%
Switch Fabric Resources
Bus utilization: current: 0%, peak was 0% at 06:09:27 UTC Fri Mar 30 2012
Fabric utilization: Ingress Egress
Module Chanl Speed rate peak rate peak
4 0 20G 0% 1% @05:42 30Mar12 0% 1% @06:09 30Mar12
5 0 20G 0% 1% @06:09 30Mar12 0% 1% @05:51 30Mar12
Switching mode: Module Switching mode
4 compact
5 compact
Interface Resources
Interface drops:
Module Total drops: Tx Rx Highest drop port: Tx Rx
no modules reported drops
Interface buffer sizes:
Module Bytes: Tx buffer Rx buffer
4 1221120 152000
IBC Resources
Module Packets/sec Total packets Dropped packets
5 RP Rx: 169 4008231 0
Tx: 2378 21942661 0
5 SP Rx: 6 158253 0
Tx: 20 227919 0
SPAN Resources
Source sessions: 16 maximum, 0 used
Type Used
Local 0
RSPAN source (max 2) 0
ERSPAN source 0
Service module 0
Destination sessions: 64 maximum, 0 used
Type Used
RSPAN destination 0
ERSPAN destination (max 24) 0
[3] sh file systems
File Systems:
Size(b) Free(b) Type Flags Prefixes
- - opaque rw system:
- - opaque rw tmpsys:
- - opaque ro flexwan-fpd:
- - disk rw disk0:
- - disk rw disk1:
* 512081920 157769728 disk rw sup-bootdisk:
148556256 0 opaque ro sup-microcode:
0 358437152 opaque wo sup-image:
127212 126656 nvram rw const_nvram:
- - opaque rw null:
- - opaque ro tar:
- - network rw tftp:
- - opaque wo syslog:
4059328 4045320 nvram rw nvram:
512081920 512081920 disk rw bootdisk:#
- - network rw rcp:
- - network rw ftp:
- - network rw http:
- - network rw scp:
- - network rw https:
- - opaque ro cns:
15990784 15990784 flash rw dfc#4-bootflash:
[4] sh module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
4 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAL1548WT2L
5 2 Route Switch Processor 720 (Active) RSP720-3CXL-GE SAL1550Y5FJ
6 0 Supervisor-Other Unknown Unknown
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ----- ------------- ------------ -------
4 649e.f30a.8168 to 649e.f30a.817f 5.1 12.2(18r)S 15.2(1)S Ok
5 2894.0fd0.e058 to 2894.0fd0.e05b 5.13 12.2(33r)SR 15.2(1)S Ok
6 0000.0000.0000 to 0000.0000.0000 0.0 Unknown Unknown Unknown
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
4 Centralized Forwarding Card WS-F6700-CFC SAL1549XAW6 4.1 Ok
5 Policy Feature Card 3 7600-PFC3CXL SAL1550Y3ZD 1.1 Ok
5 C7600 MSFC4 Daughterboard 7600-MSFC4 SAL1550Y5Y5 4.0 Ok
Mod Online Diag Status
---- -------------------
4 Pass
5 Pass
6 Not Applicable
Solved! Go to Solution.
04-02-2012 06:48 AM
It looks to me like it has not loaded any IOS. Connect to the console port of the 2nd Supervisor in slot 6 and make sure it is not stuck in ROMMON mode. If it is, then boot the same IOS as the active supervisor.
04-02-2012 06:48 AM
It looks to me like it has not loaded any IOS. Connect to the console port of the 2nd Supervisor in slot 6 and make sure it is not stuck in ROMMON mode. If it is, then boot the same IOS as the active supervisor.
04-05-2012 07:11 AM
Thank you for answer!
Second supervisor fall in rommon with wrong BOOT variable.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide