Cisco 877W - not booting Bootstrap corrupt?

[rosabenson]

Good day everyone,

I have a cisco 877w. When switching it on, all lights flash and only the "OK"light stays on. Connecting via Teraterm via console shows but a blank screen, with the cursor flashing. I have connected a different 877 series to confirm my serial connection and it works fine.

I cannot get into rommon, even if I press crtl-break.

I suspect the bootstrap to be faulty. How can I reload it onto this router? Thanks a stack!

[Mark Malone · Accepted solution]

id say its dead i have seen that before the board was gone on it those 800 series have blown few times on us , without console rommon i dont think theres an option to do anything with it apart from RMA it

[rosabenson]

Mark,
thank you . R.I.P I guess then.