10-14-2014 12:47 PM - edited 03-07-2019 09:06 PM
Configured a Cisco 887VA with ospf, everything functional.
However after a reboot of the router, now the ospf command is not visible in the command list and can't configure ospf. What is the issue?
edge-router-01(config)#router ?
odr On Demand stub Routes
ospfv3 OSPFv3
rip Routing Information Protocol (RIP)
edge-router-01#sh license
Index 1 Feature: advipservices
Period left: Life time
License Type: Permanent
License State: Active, Not in Use
License Count: Non-Counted
License Priority: Medium
Index 2 Feature: advsecurity
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
10-14-2014 12:56 PM
think i found it, had to do a 'license boot module c880-data level advipservices'
09-25-2019 07:13 PM
I just spent the last 5 minutes figuring out/resetting my Cisco login just so I can say THANKYOU.
I had the same problem and this fixed it.
09-25-2019 07:28 PM
Glad you found it. Also, usually "sh ver" is an easier command to look for the type of license you have and what it will boot to on the next reboot,
HTH
09-26-2019 05:20 AM
HI,
As I am looking that your Advance IP services license is not in use:
edge-router-01#sh license
Index 1 Feature: advipservices
Period left: Life time
License Type: Permanent
License State: Active, Not in Use
License Count: Non-Counted
License Priority: Medium
You must run command to make it active in the boot and reload the router.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide