Cisco Adaptive Security Appliance Software Version 9.4(4)18 Device Manager Version 7.9(2)
Compiled on Thu 29-Mar-18 22:10 PDT by builders System image file is "disk0:/asa944-18-smp-k8.bin" Config file at boot was "startup-config"
Hardware: ASA5512, 4096 MB RAM, CPU Clarkdale 2792 MHz, 1 CPU (2 cores) ASA: 2048 MB RAM, 1 CPU (1 core) Internal ATA Compact Flash, 4096MB
Short and Simple, i am NOT a cisco guy. I'm a level 3 IT technician and i work with Dell Sonicwall's and Fortinet Firewall's. However due to IP limitations we've migrating to Cisco so we can have32+ PublicIP's used on the firewall. Now,Ihave the device on and in our datacenter and googling the hell out of everything i'm trying to put a config together so i can go down and essentially migrate config from the current Fortigate to the Cisco ASA.
I've been to the datacenter 5 times and cannot get it rightby guessing the command line. If someone could go over my config please and see what i'm doing wrong? We basically have a bunch of virtual servers running on multiple VLAN's so what I'm trying to accomplish is the following:
Private IP A out to internet showing Public Address A.
Private IP B out to internet showing Public Address B.
Private IP C out to internet showing Public Address C.
Public IP A Port 80 forwarded to PrivateIP A port 80.
Public IP B Port 80 forwarded to PrivateIP B port 80.
Public IP C Port 80 forwarded to PrivateIP C port 80.
If i can get those parts done, it's only VPN's to do which I'm sure i'll figure out in ASDM wizard, but i cannot leave the Cisco in live until all our services are working via it, and they are down while I test it out. This is the latest script i'm going to test. I think this is right, but could do with a yes or no you need to change to this.
======================== OBJECT CREATION BEGIN ===============================