Cisco ASA 5525 policy based routing

[blehhhh11]

Hi,

I am trying to run the below commands on a Cisco ASA 5525 V01 to set the next hop for specific subnets.

route-map PBR permit 10
match ip address NET1_ACL
set ip next-hop x.x.x.x

The "set ip next-hop x.x.x.x" is not recognized. Is there anything I need to do to enable this?

Thanks,

[Philip D'Ath]

Upgrade to a minimum of 9.5.2.  I see 9.5.3 is available for this platform now, so I would go with that.