Cisco ASA 5545 - Need internal LAN to be able to connect to Public IP

[virtuali]

Hi All,

I am fairly new to Cisco ASA and ASDM so bare with me.. I am trying to be able to get my internal network IE: 10.1.60.25 to be able to connect/telnet to a IE: public IP 204.13.54.45 that is config on one of my local interfaces.  If I try to connect from an ext IP to the public IP I can just fine, but when I try from my local LAN to 204.13.54.45 I cant.  I need some assistance in creating the NAT/Firewall rules to allow me to connect to the public IP from the internal network.

Thanks in advance.

[Georg Pauwen]

Hello,

the first thing to check is of you have:

same-security-traffic permit inter-interface

configured on your ASA.

If that doesn't help, post the full configuration of your ASA...

[virtuali]

Hi George,

I have the below conf:

same-security-traffic permit inter-interface
same-security-traffic permit intra-interface

[Georg Pauwen]

Hello,

yes, that needs to be in there.

Can you post the full configuration of your ASA ?

[virtuali]

Just posted it to you PM..

Tks u.