Hi, I’m a bit confused about the new Licensing on the cisco ASR 1001x. I have two licenses on paper for, Ipsec FW AVC and 10 GE 1 port license.
How do I go about activating the IPSEC/10 gig license, show license feature shows that it’s not enabled. How do I enable this, does this happen when I start to use ipsec related commands? Does it go from Eval to RTU license on this own? I ask because I know some license features you need to activate it yourself like the throughput license, platform hardware throughput level XXX. Likewise how do I active the 10 Gig port, does this also happen once I install the SFP ?
Also Im on license suite, adventerprise, does this mean that if I change the suite to AdvUCSuiteK9 I will see different features ?
Thanks, Paul
Cisco IOS XE Software, Version 16.08.01
Cisco IOS Software [Fuji], ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.8.1, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2018 by Cisco Systems, Inc.
Compiled Tue 27-Mar-18 13:43 by mcpre
License Type: Permanent
License Level: adventerprise
Next reload license Level: adventerprise
ASR1001X- temp#sh license feature | in ipsec|inter|adve
adventerprise yes yes no yes yes
internal_service yes no no no no
ipsec yes yes no no yes
interface_10g yes yes no no yes
interface_10g_x2 yes yes no no no
OC12_wan_interface yes yes no no yes
OC3_wan_interface yes yes no no yes
ASR1001X -temp#sh platform hardware throughput ?
level Show the current traffic throughput level
ASR1001X -temp#sh platform hardware throughput l
ASR1001X-Baycoast-temp#sh platform hardware throughput level
The current throughput level is 2500000 kb/s
