07-17-2019 04:37 AM
I have 2 sw cat 9404 in virtual stacking after vss came up
I configured switches the configuration is automatically erased
This happens 2 times
I save configuration every time.
07-17-2019 05:05 AM
Check your confreg, issue "show version"
07-18-2019 12:56 AM
check if the rommon variable is bypassing the startup configuration
force the switch into rommon by pressing ctrl+c when it starts booting up
once you see the "switch:" prompt check for following
switch: set
check if you see following variable set to 1 in output
SWITCH_IGNORE_STARTUP_CFG=1
if you see the above then set it as 0 and reset
switch:SWITCH_IGNORE_STARTUP_CFG=0
switch:reset
This should stop the switch from ignoring the startup config
you can refer some more here
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide