we have a cisco router 2911 and 2 cisco catalyst 3650 the switch B is conected to siwtch A, and switch A is conected to Router, also we have a tp link 16 fastethernet, we have a survilliance system on our network, and we hve diferent kind of cameras ip, but we have 2 cameras that only work if we conect to tp-link switch, if we connect to cisco switch they never get connnected, we tried spanning-tree portfast, and with this they link dont go down, but the never get ip address, if we move the camera to any port of the switch the same time happen.
what i am missing
Switch#sh int fa 0/31
FastEthernet0/31 is up, line protocol is up (connected)
Hardware is Fast Ethernet, address is 001a.6dea.be23 (bia 001a.6dea.be23)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 8/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 3458000 bits/sec, 524 packets/sec
5 minute output rate 54000 bits/sec, 87 packets/sec
1754906 packets input, 1436175903 bytes, 0 no buffer
Received 139 broadcasts (4 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 4 multicast, 3 pause input
0 input packets with dribble condition detected
259750 packets output, 20900446 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
we already change cable.
