Dear Sir,
Our customer get the problem that the switch count the 5mins input/output rate of connected traffic interface always ZERO.
The problem only occur in the module 3,4 and 5 interface, module 2 has no problems.
May I ask are there any software bug will cause this issue????
-------------------------------------------------------------------------------------------------
Catayst 4506E
12.2(52)SG
Chassis Type : WS-C4506-E
Power consumed by backplane : 0 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 6 Sup 6-E 10GE (X2), 1000BaseX (SFP) WS-X45-SUP6-E
2 48 10/100/1000BaseT (RJ45) WS-X4548-GB-RJ45
3 48 10/100/1000BaseT (RJ45) WS-X4648-RJ45-E
4 48 10/100/1000BaseT (RJ45) WS-X4648-RJ45-E
5 48 10/100/1000BaseT (RJ45) WS-X4648-RJ45-E
GigabitEthernet2/3 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet Port, address is 0024.1441.12d2 (bia 0024.1441.12d2)
Description: *** HTTP Server-1 p3 ***
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000-TX
input flow-control is on, output flow-control is on
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters 30w5d
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 248348
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 45000 bits/sec, 14 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
656490115 packets output, 439577149306 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
GigabitEthernet3/1 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet Port, address is 68ef.bdfd.dbb9 (bia 68ef.bdfd.dbb9)
Description: ** Automation DEV-2 **
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000-TX
input flow-control is on, output flow-control is on
Auto-MDIX on (operational: on)
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters 30w5d
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
12138884114 packets input, 18042976913749 bytes, 0 no buffer
Received 128075 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
16314804370 packets output, 2098191873853 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
-------------------------------------------------------------------------------------------------
Million Thanks
Thanks and regards,
Philip
