Cisco Catalyst WS-C2960-24TT-L - POE Problem

[mikidosrl00]

Partners:

I have in my lan 4 switches WS-C2960-24TT-L and recently my company is buying IP Avaya Hardphones.

They need a power supply. Avaya tells me that I should enable POE in my switch for the telephones can be able to receive power.

I search everywhere , but I could´t finf information if this switches supports (or not)  POE.

I figured it out to access the por configuration. But when I type POWER INLINE , OR POWER command, or Show Power Inline, insede the terminal configuration , y Receive "Invalid input detectedat market" (I am attaching a link image of th error)

Is it posible that this switch does not support POE?

Any help will be appreciatted!

Thanks

[Collin Clark]

Post a show version and we can tell you if you have a PoE switch or not.

[Adam Casella]

Hey,

In the future, you can also run the command "show power inline" or "show env power"  and you can see if a PoE power supply is in this device.  If there is  PoE power supply it will state the available PoE power.

However, the WS-C2960-24TT-L does not support PoE.  Look at the link below:

http://www.cisco.com/en/US/products/ps6406/prod_models_comparison.html

Thanks,

Adam

[mikidosrl00]

Here is the Show Version.

Thanks again!

http://img258.imageshack.us/img258/1628/showversion2960.jpg

[Collin Clark]

No PoE on that switch. You will have to use an external power patch panel, use the wall wart power supply for the phone, or replace the switch with a powered one.

Hope it helps.

[Leo Laohoo]

This model does not support PoE (as what everyone said).  PoE models normally have a "P" suffix at the end of the model number.

You can also use in-line power switch.  One of Cisco's partner/supplier is PowerDsine.