Cisco CatOS 4506 ports faulty

[Suresh Babu]

Hi,

In Cisco 4506 CATOS switch in show port output shows some ports are faulty...

3/1                     faulty     41         normal   auto  auto 10/100BaseTX

3/2                     faulty     41         normal   auto  auto 10/100BaseTX

3/3                     faulty     41         normal   auto  auto 10/100BaseTX

3/4                     faulty     41         normal   auto  auto 10/100BaseTX

3/5                     faulty     41         normal   auto  auto 10/100BaseTX

3/6                     faulty     41         normal   auto  auto 10/100BaseTX

3/7                     faulty     41         normal   auto  auto 10/100BaseTX

3/8                     faulty     41         normal   auto  auto 10/100BaseTX

3/1                     faulty     41         normal   auto  auto 10/100BaseTX

3/2                     faulty     41         normal   auto  auto 10/100BaseTX

3/3                     faulty     41         normal   auto  auto 10/100BaseTX

3/4                     faulty     41         normal   auto  auto 10/100BaseTX

3/5                     faulty     41         normal   auto  auto 10/100BaseTX

3/6                     faulty     41         normal   auto  auto 10/100BaseTX

3/7                     faulty     41         normal   auto  auto 10/100BaseTX

3/8                     faulty     41         normal   auto  auto 10/100BaseTX

Any one please guide me to clear this issue...

Rgds

Suresh

[Reza Sharifi]

Hi,

Is this happening to only few ports in this blade?

You may want to reset the blade and see if the issue still persist.

HTH

[Suresh Babu]

HI Reza,

Yes, It is happening only for few ports in the module....

Rgds

Suresh

[Reza Sharifi]

Hi,

When this happens, usually the blade is gone bad.  You can take the blade out of the chassis and insert it back in and see if there is a change.  If not, you may have to RMA the blade.

HTH