cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
870
Views
0
Helpful
1
Replies

Cisco Cisco C1101-4PLTEP Chassis with 4G-LTE Module Configuration assistance.

Khaled Shalati
Level 1
Level 1

I am new to the cellular configuration and my configuration doesn't seem to work.

 

The SIM card is a data-only US Verizon carrier 

 

sh run: controller

controller Cellular 0/2/0
lte sim data-profile 1 attach-profile 1 slot 0
no lte gps enable
lte modem link-recovery rssi onset-threshold -110
lte modem link-recovery monitor-timer 20
lte modem link-recovery wait-timer 10
lte modem link-recovery debounce-count 6
lte modem crash-action boot-and-hold
description Verizon

 

sh run: interface

interface Cellular0/2/0
bandwidth 2000
ip address negotiated
no ip unreachables
dialer in-band
dialer idle-timeout 30
dialer watch-group 1
dialer-group 1
ipv6 enable
pulse-time 1
ip virtual-reassembly

 

sh run: dialer

dialer watch-list 1 delay route-check initial 60
dialer watch-list 1 delay connect 1
dialer-list 1 protocol ip permit

 

Router#sh ip int b
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0/0 unassigned YES NVRAM down down
GigabitEthernet0/1/0 unassigned YES unset down down
GigabitEthernet0/1/1 unassigned YES unset down down
GigabitEthernet0/1/2 unassigned YES unset down down
GigabitEthernet0/1/3 unassigned YES unset down down
Cellular0/2/0 unassigned YES NVRAM up up
Cellular0/2/1 unassigned YES TFTP down down
Loopback0 192.168.1.1 YES manual up up
Vlan1 unassigned YES unset up down

 

Router#sh cellular 0/2/0 profile

Profile 1 = INACTIVE* **
--------
PDP Type = IPv4
Access Point Name (APN) = vzwinternet
Authentication = None

Profile 2 = INACTIVE
--------
PDP Type = IPv4
Access Point Name (APN) =
Authentication = None

Profile 3 = INACTIVE
--------
PDP Type = IPv4v6
Access Point Name (APN) = vzwinternet
Authentication = None

Profile 4 = INACTIVE
--------
PDP Type = IPv4v6
Access Point Name (APN) = vzwapp
Authentication = None

Profile 5 = INACTIVE
--------
PDP Type = IPv4v6
Access Point Name (APN) = vzw800
Authentication = None

Profile 6 = INACTIVE
--------
PDP Type = IPv4v6
Access Point Name (APN) = vzwclass6
Authentication = None

* - Default profile
** - LTE attach profile


Configured default profile for active SIM 0 is profile 1.

 

 

I have both of the Antenna screwed in, please help!

 

1 Reply 1

TD_Werner
Level 1
Level 1

could you resolve this?

Review Cisco Networking for a $25 gift card