Switching

dirDirectory of flash:/589827 -rw- 2097152 Nov 4 2024 08:53:23 +04:30 nvram_config_bkup589826 -rw- 2097152 Nov 4 2024 08:53:23 +04:30 nvram_config647169 drwx 4096 Nov 3 2024 20:56:42 +04:30 .installer589866 -rw- 0 Nov 3 2024 20:45:50 +04:30 dope_hist...

Hello All,   can anyone tell me why we are not able to sync NTP from Nexus 9504, 93180, 92160, two command we configured:   #ntp server 10.x.x.x prefer#ntp source-interface  Vlan (mgmt)   We are able to sync from WAN router but not any of the Nexus s...

Hi I have 2 output gateway 1 and 2I used route-map math by ip community listand set next-hop gateway 2When add this rule in route-map all traffic redirect to gateway-2  In nexus 9KHow can do this by community tag65000:100 community redirect to gatewa...

There is the following setup:1. 9200 switch with 2 VLANs.VLAN 1: 10.0.1.0/24, IP 10.0.1.1VLAN 2: 10.0.2.0/24, IP 10.0.2.12. Main router on VLAN 1: 10.0.1.2.3. 9200 routes everything to 10.0.1.2 (main router) by a static route: 0.0.0.0 -> 10.0.1.2.Whe...

Not sure whether it is normal or not, but when I restart the switch, there is no alarm showing that system is unreachable or restarted.Only the interface up/down errors.  When I worked with the switches from other vendors, there is critical alarms sh...

I have a switch 2960 model, in which hosts connected to it are taking around 30 secs to turn on lan connection  after waking up from sleep mode. Currently it is running on PVST mode. Is there any option to make it fast to turn on LAN?

I recently replaced a customer's 3750 stack with a 9300L stack (C9300L-24UXG-4X).  Attached to this stack are two HP blade centres.  About 24 hours after the new stack was in, the customer started experiencing intermittent packet loss to both blade c...

Hi community, I have stumbled upon an interesting problem. The Standby RP, switch 1 currently, is suffering from high memory utilization which could only be discovered by Cisco DNAC and this command: show platform software status control-processor.  ...

Hello,Running into an issue of we are not able to get the 3750 running version 12.2(55)SE3 to communicate with ISE.  I'll post the current config we have here below for assistance:    aaa new-model ! ! aaa group server tacacs+ ISE_TACACS server 192....

I have a question regarding static multicast configuration on a Cisco device. Is it possible to have static multicast route only with out PIM configuration? we have another 3'rd party router connected to cisco switch which does not support PIM.Is it ...

Hi Everyone, I cannot seem to connect an idf switch (Catalyst 9300) to our main MDF Nexus 5548.I have verified light at the IDF.  I have for example light on side A of fiber going into switch, verified light on Side B coming out of switch/transceiver...