03-31-2017 04:53 PM - edited 03-08-2019 10:00 AM
Aloha! I have a Cisco IE 1000 (industrial grade switch) and would like to set the default "Admin" account password but it says I can't do it because I didn't enter a username, and that's because it is grayed out, so you can't enter a UserName.
04-01-2017 05:17 AM
Hello,
the default username is blank, and the default password is 'cisco'.
Have you tried the Express Setup as described in the document below ?
http://www.cisco.com/c/en/us/td/docs/switches/lan/cisco_ie1000/hardware/installation/guide/ie1000_hig/HIGEXPRESS.html
04-10-2017 12:49 PM
Aloha Georg!
sorry, I replied a week or so ago but I guess that doesn't work. Yes, I have tried the express setup a few times, and even reset the switch to factory defaults, it always responds the same way. also, when I run the express setup, the GUI suppose to have a place to enter a new password, and that is missing. the pamphlet shows how it should look but it doesn't match. I'm also on firmware 1.3 which I think is the latest.
Thanks!
jc
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide