Cisco mds question
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-11-2024
09:18 AM
- last edited on
08-11-2024
10:34 AM
by
rupeshah
Has anyone been able to successfully remove switchport fill-pattern idle speed 8000 command? When i put no in front of it, it says invalid command and not been able to find a way to default the interface.
We replaced 8gb sfp with 32gb ones but this command still persists even when you shutdown the port to try and remove that command.
Appreciate any help. Thanks
- Labels:
-
Catalyst 8000
-
Other Switches
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-11-2024 10:49 AM
- Sometimes you have 'default interface ...' to force to go to a default interface setting , if available you could try it and
configure the needed settings again ,
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
