Cisco N9K-C93108TC-EX fail to boot

vsivietnam · ‎08-14-2021

My switch Cisco N9K-C93108TC-EX fail to boot.

It keep checking for iPXE and Autoboot failed.

Please find the log in attached file.

Please advise me the way to fix this error because my device just out of warranty for 3 months.

Many thanks,

manojs87910 · ‎08-14-2021

Reboot the device while installing press below commands,

Ctrl+c

cmdline recoverymode=1

boot (Image Version)

marce1000 · ‎08-14-2021

- Does anything happen when you type Ctrl+B , the idea is to try this before the Autoboot failed, reboot message is displayed , actually try this within 3 seconds , after the sequence starts.

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Georg Pauwen · ‎08-14-2021

Hello,

according to he iPXE website:

"However, if you see a message such as

Waiting for link-up on net0... failed: Down (http://ipxe.org/38086101)
then you should check that the cable is plugged in, and that any link lights are on."

Check your physical setup (cabling etc.)...