08-14-2021 03:05 AM
My switch Cisco N9K-C93108TC-EX fail to boot.
It keep checking for iPXE and Autoboot failed.
Please find the log in attached file.
Please advise me the way to fix this error because my device just out of warranty for 3 months.
Many thanks,
08-14-2021 03:49 AM
Reboot the device while installing press below commands,
Ctrl+c
cmdline recoverymode=1
boot (Image Version)
08-14-2021 03:50 AM
- Does anything happen when you type Ctrl+B , the idea is to try this before the Autoboot failed, reboot message is displayed , actually try this within 3 seconds , after the sequence starts.
M.
08-14-2021 05:00 AM
Hello,
according to he iPXE website:
"However, if you see a message such as
Waiting for link-up on net0... failed: Down (http://ipxe.org/38086101)
then you should check that the cable is plugged in, and that any link lights are on."
Check your physical setup (cabling etc.)...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide