Cisco nat or ACL issue

[Ayushjav Lkhagvasuren]

Hi all. I have Cisco 892F router, SG300-28P switch & Cisco 541 APs. So i divided wireless LAN to 2 seperate VLANS. But no traffic except VLAN 1 cannot pass through the 892 router and connect to the Internet. I couldn;t know where the problem is. All i know is that, switch and AP's configs are right. Because clients can obtain AP address from router through access point. Only problem is AP clients can connect to the router, but still can't connect to Internet. I attached Cisco router config file. Please help me. I am waiting for your reply.

Thanks,

Ayush

[v-ragupt · Accepted solution]

Hello Ayushjav,

Are you able to browse internet from ethernet ports assigned in vlan 3 on router itself.

[Ayushjav Lkhagvasuren]

Yes it is possible to browse Internet via VLAN 3

[cadet alain]

Hi,

first can you add this to your config and try to go to internet from a failing vlan and post any log output:

logging buffered

ip inspect log drop-pkt

"do your test like a ping to 8.8.8.8"

do sh log --->  post the output here

Regards

Alain

Don't forget to rate helpful posts.