cisco nexus 7000 - no int range command

[robertkwild]

hi all,

i have configured ciscos before and i can normally configure a range of interfaces like -

conf t

#int range g10/13-24

then my commands...

but this switch seems to not support the range command

thanks,

rob

[Mark Elsen]

 -  Could you leave a blank before and after the hyphen. Check is this helps.

 M.

[robertkwild]

that wont help as the switch doesnt even have the command for "range"

# int ?
breakout Configuring the breakout for an interface
ethernet Ethernet IEEE 802.3z
loopback Loopback interface
mgmt Management interface
port-channel Port Channel interface
vlan Vlan interface

[Mark Elsen · Accepted solution]

 - Could you just avoid the range word in your initial command (test)  ?

   M.

[robertkwild]

nice one!!!!!

it worked